I can't place my work bench anywhere I want.

ElCabong

Survivor
I added two 5x2 blocks to the length of my base and could not place the work base there. So I added two more 5x2 blocks. It's still would not let me place it there. I don't understand what's going on.I know would work in a19.

 
Are any of those 5x2 blocks visually deceiving? E.g. plates which only take up what appears to be a few cm, but the block is then used? 

I mistakenly did a base design where I had the plate on the bottom of the bock, o anything I put on top of it "floated" 90% of a block off the ground. Same thing happens with like poles, walls, switches, torches etc.

 
Are any of those 5x2 blocks visually deceiving? E.g. plates which only take up what appears to be a few cm, but the block is then used? 

I mistakenly did a base design where I had the plate on the bottom of the bock, o anything I put on top of it "floated" 90% of a block off the ground. Same thing happens with like poles, walls, switches, torches etc.
No these are valid blocks that I placed and upgraded to wood blocks

 
Is it a height issue?  Meaning, is your ceiling too low to place them?  Try it in a base with a higher ceiling to see if that affects the outcome.

 
The problem went away when I built a roof over the ledge I was trying to place the workstation on. I have placed workstations out in the open on a ledge before. So I'm not sure what was going on.

 
Back
Top