Tahaan
Refugee
I often use basic bulbs as "indicators" to show that something has power. But sometimes I have too many in a small area which causes that area to be so overly bright that it is just stupidly unpeasant to look at.
I wish I could set them to a lower value, eg 20%.
How hard would it be to create a light-bulb with a brightness setting?
If that is difficult, then how about just version of the basic bulb that gives a very low light (and ideally uses less power).
What would have been even better would be an indicator panel that shows say up to 4 other specific things to show whether they are on or off ... but that Iimagine is in a different league.
I wish I could set them to a lower value, eg 20%.
How hard would it be to create a light-bulb with a brightness setting?
If that is difficult, then how about just version of the basic bulb that gives a very low light (and ideally uses less power).
What would have been even better would be an indicator panel that shows say up to 4 other specific things to show whether they are on or off ... but that Iimagine is in a different league.