Physics.PhsX QuickHullLibrary

Based on your post in the Mods section, this might be related to a mods issue.  However, you will get better help with more detail information as outlined in the link I have in this post.

 
Last edited by a moderator:
Sounds like a known issue with electric fence posts (in rare cases - very rare cases - generators) where it's not hooking up properly in code (long story short). Usually they will have issues like wires drooping like the posts are broken, hooked up to the bottom etc.

Unhooking, picking up the posts, then placing them back down and re-wiring usually fixes this. Each error will mean one hookup. Worst case and easiest fix is to delete the power.dat and power.bak from the saved game folder. Note this will delete any batteries, gas, ammo, solar panels, etc. stored in any generators/traps/etc., so remove those first. It will also remove all the wiring so you'll have to re-do all of that. But, it's worked a couple of times doing that myself in testing, ofc your milage may vary.

Hope this helps. But yes, anything further we would need a log, info found in the link BFT2020 posted.

 
I unwired everything cept my fence to fence connection and it removed the error now to rehook everything hows to best avoid getting the error or is it something that can just happen time to time?

 
Glad it worked. I haven't worked out a complete comfirmation on a 100% cause ( though it is being worked on), but it seems to happen more often when fence post wires cross other sets of wires or going through tripwires and other odd-elevated setups.

I suggest remembering how the bad ones were setup and maybe change it somehow, though again this isn't a 100% prevention. 

 
I took that advice, Im hoping my rewiring job works well I dont see any overlapping wires. Ive been using a hallway with fences since 18 i think maybe just the very start of 19. First time noticing this issue :(

 
You must log in or register to reply here.
Back
Top