Motion Sensored (Open/Close) Draw Bridges

[Applesauce]

Motion sensor to electric timer relay to drawbridges to get vehicles inside and out of your base without having to get off/out of your vehicle.

Upvote for laziness :fat:

 

[Wyndrunner2002]

I'd be all for it, so long as zombies also triggered the sensor.

 

[Applesauce]

I'd be all for it, so long as zombies also triggered the sensor.

Well I would hope to see where you could set it for allies, strangers, zombies etc.

 

[Smugger]

I have already posted on this before: https://7daystodie.com/forums/showthread.php?119054-In-Line-Power-Sources-Selective-Mode-Motion-Senors-amp-Electric-Doors-Drawbridge

I even cover the fact that motion sensors are not triggered when in a Vehicle.

 

[Applesauce]

I have already posted on this before: https://7daystodie.com/forums/showthread.php?119054-In-Line-Power-Sources-Selective-Mode-Motion-Senors-amp-Electric-Doors-Drawbridge
I even cover the fact that motion sensors are not triggered when in a Vehicle.

See so we think alike! Although, you explained it better than I did lol

 

[Smugger]

Ya, it would be great if the motion sensors could be triggered even when in a vehicle, I think that is the first major hurdle. But having a selective activation mode motion sensors would be great then to use with an electric drawbridge or doors.

It does kind of suck to have to get out of your vehicle and run up to open a drawbridge and get back in the vehicle drive it in then get back out "Again" to close it.

I hope electric drawbridges become a thing. And fix motion sensor detection while in vehicles.

Cross your fingers!

:friendly_wink: :nevreness: